LA-ICP-MS analyses of Fe-rich alloys: Quantification of matrix effects for 193 nm excimer laser systems

E. S. Steenstra, J. Berndt, S. Klemme, W. Van Westrenen

Research output: Contribution to JournalArticleAcademicpeer-review

Abstract

Laser-ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) is increasingly used to determine major, minor and trace element concentrations in Fe-rich alloys. In the absence of matrix-matched standards, standardization is often based on silicate glass reference materials. This approach could result in significant matrix effects. Here, we quantify these matrix effects for a wide suite of volatile to refractory trace elements during ns-excimer LA-ICP-MS analyses of Fe-rich alloys by comparing measured LA-ICP-MS concentrations with results from electron microprobe analysis (EPMA). Measurements performed with LA-ICP-MS consistently overestimate the concentration of volatile elements in metals relative to concentrations measured by EPMA. In contrast, the concentrations of non-volatile and refractory elements in Fe-rich alloys are systematically underestimated with LA-ICP-MS relative to EPMA. To quantitatively describe these offsets, we consider the fractionation index (F i ) for element i, or the ratio between the EPMA- and LA-ICP-MS determined elemental concentrations. The F i is found to be independent of concentration and type of Fe-rich alloy considered, and ranges from >0.14 for the most volatile elements to ≤1.8 for the most refractory elements. The F i correlate positively with the 50% condensation temperature of the elements considered, suggesting the matrix effects are predominantly the result of ablation-induced evaporative and/or melting processes at the ICP site. Comparison of the results with results from previous studies obtained for metals and sulfides using similar laser systems for a smaller subset of elements generally confirms the magnitude of the observed matrix effects for metals. These results were used to quantify the effects of matrix effects on calculated metal-silicate partition coefficients (D, defined as the metal to silicate abundance ratio by weight) derived from high-pressure experiments. The comparison was done by considering uncorrected and corrected LA-ICP-MS derived metal concentrations, where ''corrected'' concentrations were obtained by multiplying uncorrected LA-ICP-MS values with the appropiate F i values derived here. Our results show that neglecting matrix effects will result in erroneous partitioning results for many volatile and refractory elements. The matrix effects described here should therefore be taken into account in future applications of ns-LA-ICP-MS for Fe-rich metal analysis if metal standards are not available for calibration.

Original languageEnglish
Pages (from-to)222-231
Number of pages10
JournalJournal of Analytical Atomic Spectrometry
Volume34
Issue number1
Early online date5 Dec 2018
DOIs
Publication statusPublished - 1 Jan 2019

Fingerprint

Inductively coupled plasma mass spectrometry
Excimer lasers
Laser ablation
Electron probe microanalysis
Metals
Fractionation
Silicates
Refractory materials
Trace Elements
Metal analysis
Sulfides
Ablation
Standardization
Condensation
Melting
Calibration
Glass
Lasers

Cite this

@article{e38529b55da54b099bd6dac13f21b792,
title = "LA-ICP-MS analyses of Fe-rich alloys: Quantification of matrix effects for 193 nm excimer laser systems",
abstract = "Laser-ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) is increasingly used to determine major, minor and trace element concentrations in Fe-rich alloys. In the absence of matrix-matched standards, standardization is often based on silicate glass reference materials. This approach could result in significant matrix effects. Here, we quantify these matrix effects for a wide suite of volatile to refractory trace elements during ns-excimer LA-ICP-MS analyses of Fe-rich alloys by comparing measured LA-ICP-MS concentrations with results from electron microprobe analysis (EPMA). Measurements performed with LA-ICP-MS consistently overestimate the concentration of volatile elements in metals relative to concentrations measured by EPMA. In contrast, the concentrations of non-volatile and refractory elements in Fe-rich alloys are systematically underestimated with LA-ICP-MS relative to EPMA. To quantitatively describe these offsets, we consider the fractionation index (F i ) for element i, or the ratio between the EPMA- and LA-ICP-MS determined elemental concentrations. The F i is found to be independent of concentration and type of Fe-rich alloy considered, and ranges from >0.14 for the most volatile elements to ≤1.8 for the most refractory elements. The F i correlate positively with the 50{\%} condensation temperature of the elements considered, suggesting the matrix effects are predominantly the result of ablation-induced evaporative and/or melting processes at the ICP site. Comparison of the results with results from previous studies obtained for metals and sulfides using similar laser systems for a smaller subset of elements generally confirms the magnitude of the observed matrix effects for metals. These results were used to quantify the effects of matrix effects on calculated metal-silicate partition coefficients (D, defined as the metal to silicate abundance ratio by weight) derived from high-pressure experiments. The comparison was done by considering uncorrected and corrected LA-ICP-MS derived metal concentrations, where ''corrected'' concentrations were obtained by multiplying uncorrected LA-ICP-MS values with the appropiate F i values derived here. Our results show that neglecting matrix effects will result in erroneous partitioning results for many volatile and refractory elements. The matrix effects described here should therefore be taken into account in future applications of ns-LA-ICP-MS for Fe-rich metal analysis if metal standards are not available for calibration.",
author = "Steenstra, {E. S.} and J. Berndt and S. Klemme and {Van Westrenen}, W.",
year = "2019",
month = "1",
day = "1",
doi = "10.1039/c8ja00291f",
language = "English",
volume = "34",
pages = "222--231",
journal = "Journal of Analytical Atomic Spectrometry",
issn = "0267-9477",
publisher = "Royal Society of Chemistry",
number = "1",

}

LA-ICP-MS analyses of Fe-rich alloys : Quantification of matrix effects for 193 nm excimer laser systems. / Steenstra, E. S.; Berndt, J.; Klemme, S.; Van Westrenen, W.

In: Journal of Analytical Atomic Spectrometry, Vol. 34, No. 1, 01.01.2019, p. 222-231.

Research output: Contribution to JournalArticleAcademicpeer-review

TY - JOUR

T1 - LA-ICP-MS analyses of Fe-rich alloys

T2 - Quantification of matrix effects for 193 nm excimer laser systems

AU - Steenstra, E. S.

AU - Berndt, J.

AU - Klemme, S.

AU - Van Westrenen, W.

PY - 2019/1/1

Y1 - 2019/1/1

N2 - Laser-ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) is increasingly used to determine major, minor and trace element concentrations in Fe-rich alloys. In the absence of matrix-matched standards, standardization is often based on silicate glass reference materials. This approach could result in significant matrix effects. Here, we quantify these matrix effects for a wide suite of volatile to refractory trace elements during ns-excimer LA-ICP-MS analyses of Fe-rich alloys by comparing measured LA-ICP-MS concentrations with results from electron microprobe analysis (EPMA). Measurements performed with LA-ICP-MS consistently overestimate the concentration of volatile elements in metals relative to concentrations measured by EPMA. In contrast, the concentrations of non-volatile and refractory elements in Fe-rich alloys are systematically underestimated with LA-ICP-MS relative to EPMA. To quantitatively describe these offsets, we consider the fractionation index (F i ) for element i, or the ratio between the EPMA- and LA-ICP-MS determined elemental concentrations. The F i is found to be independent of concentration and type of Fe-rich alloy considered, and ranges from >0.14 for the most volatile elements to ≤1.8 for the most refractory elements. The F i correlate positively with the 50% condensation temperature of the elements considered, suggesting the matrix effects are predominantly the result of ablation-induced evaporative and/or melting processes at the ICP site. Comparison of the results with results from previous studies obtained for metals and sulfides using similar laser systems for a smaller subset of elements generally confirms the magnitude of the observed matrix effects for metals. These results were used to quantify the effects of matrix effects on calculated metal-silicate partition coefficients (D, defined as the metal to silicate abundance ratio by weight) derived from high-pressure experiments. The comparison was done by considering uncorrected and corrected LA-ICP-MS derived metal concentrations, where ''corrected'' concentrations were obtained by multiplying uncorrected LA-ICP-MS values with the appropiate F i values derived here. Our results show that neglecting matrix effects will result in erroneous partitioning results for many volatile and refractory elements. The matrix effects described here should therefore be taken into account in future applications of ns-LA-ICP-MS for Fe-rich metal analysis if metal standards are not available for calibration.

AB - Laser-ablation inductively coupled plasma mass spectrometry (LA-ICP-MS) is increasingly used to determine major, minor and trace element concentrations in Fe-rich alloys. In the absence of matrix-matched standards, standardization is often based on silicate glass reference materials. This approach could result in significant matrix effects. Here, we quantify these matrix effects for a wide suite of volatile to refractory trace elements during ns-excimer LA-ICP-MS analyses of Fe-rich alloys by comparing measured LA-ICP-MS concentrations with results from electron microprobe analysis (EPMA). Measurements performed with LA-ICP-MS consistently overestimate the concentration of volatile elements in metals relative to concentrations measured by EPMA. In contrast, the concentrations of non-volatile and refractory elements in Fe-rich alloys are systematically underestimated with LA-ICP-MS relative to EPMA. To quantitatively describe these offsets, we consider the fractionation index (F i ) for element i, or the ratio between the EPMA- and LA-ICP-MS determined elemental concentrations. The F i is found to be independent of concentration and type of Fe-rich alloy considered, and ranges from >0.14 for the most volatile elements to ≤1.8 for the most refractory elements. The F i correlate positively with the 50% condensation temperature of the elements considered, suggesting the matrix effects are predominantly the result of ablation-induced evaporative and/or melting processes at the ICP site. Comparison of the results with results from previous studies obtained for metals and sulfides using similar laser systems for a smaller subset of elements generally confirms the magnitude of the observed matrix effects for metals. These results were used to quantify the effects of matrix effects on calculated metal-silicate partition coefficients (D, defined as the metal to silicate abundance ratio by weight) derived from high-pressure experiments. The comparison was done by considering uncorrected and corrected LA-ICP-MS derived metal concentrations, where ''corrected'' concentrations were obtained by multiplying uncorrected LA-ICP-MS values with the appropiate F i values derived here. Our results show that neglecting matrix effects will result in erroneous partitioning results for many volatile and refractory elements. The matrix effects described here should therefore be taken into account in future applications of ns-LA-ICP-MS for Fe-rich metal analysis if metal standards are not available for calibration.

UR - http://www.scopus.com/inward/record.url?scp=85059596848&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85059596848&partnerID=8YFLogxK

U2 - 10.1039/c8ja00291f

DO - 10.1039/c8ja00291f

M3 - Article

VL - 34

SP - 222

EP - 231

JO - Journal of Analytical Atomic Spectrometry

JF - Journal of Analytical Atomic Spectrometry

SN - 0267-9477

IS - 1

ER -