Lithospheric-scale analogue modelling of collision zones with a pre-existing weak zone, in "Deformation Mechanisms, Rheology and Tectonics: from Minerals to the Lithosphere"

Lithospheric-scale analogue experiments have been conducted to investigate the influence of strength heterogeneities on the distribution and mode of crustal-scale deformation, on the resulting geometry of the deformed area, and on its topographic expression. Strength heterogeneities were incorporated by varying the strength of the crust and upper mantle analogue layers and by implementing a weak plate or part-of-a-plate between two stronger ones. Three (brittle crust/ viscous crust/strong viscous upper mantle) and four (brittle crust/ viscous crust/brittle upper mantle/strong viscous upper mantle) layer models were confined by a weak silicone layer on one side in order to contain but not oppose lateral extrusion. Experimental results show that relative strength contrasts between converging plates and intervening weak plates control the location and the shape of deformation sites taken as 'collision orogens'. If the contrast is small, internal deformation of the strong plates through fore- and backthrusting occurs early in the deformation history. However, the bulk system is dominated by buckling that nucleates on the weak plate whose antiformal topography is highest; model Moho of the bordering stronger plates is deepest under these conditions. If the contrast is large, deformation remains localized within the weak plate for a larger amount of shortening and develops a root zone below a narrow deformation belt, which coincides with the locus of maximum topography. Implementing a buoyant, low-viscosity layer above the model Moho of the weak plate favours the development of asymmetric model orogens notwithstanding the initial symmetric setup. Once the asymmetry is established strain remains localized in thrust faults and ductile shear zones documenting foreland directed displacement of the model orogen. Such laterally and vertically irregular configurations have applications in continent-continent collision settings such as the Eastern Alps. First-order mechanical boundary conditions recognized from modelling to be favourable to the post early Oligocene tectonics of the Eastern Alps include: (1) subtle rather than high-strength contrasts between the Adriatic indentor and the strongly deformed region comprising Penninic and Austroalpine units to the north of it; (2) decoupling of Penninic continental upper crust from its substratum to allow for crustal-scale buckling of the Tauern Window; (3) weak mechanical behaviour of the European lower crust during collision to account for its constant thickness along the TRANSALP deep seismic transect; and (4) the direct continuation of the basal detachment underlying the fold and thrust belt in the hangingwall of the European plate with a wide ductile shear zone in the core of the orogen, which separates the European from the Adriatic plate. © The Geological Society of London 2005.